Help CUN-U29 dead need help

MagicToilet

Active Member
Aug 13, 2018
50
13
Boracay Island, Philippines
hi sir . pls help on my Huawei CUN-U29 dead when i recieve .i cant find isp pin out on internet so i remove the emmc from the board and put it in ic friend and flashed firmware .Success fashing but the the phone wont turn on.

here is the logs
Operation: Write by vendor (MediaTek)

Partition name: PRELOADER
Filename: preloader_hq6582_we_b1b_l1.bin , Offset: 000000000000 , filesize: 123104 bytes
eMMC switching to ROM2
Erasing partition...
Writing partition...
Done writing partition. Write speed: 326.39 KB/s
Partition name: MBR
Filename: MBR , Offset: 000001400000 , filesize: 512 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 47.32 KB/s
Partition name: EBR1
Filename: EBR1 , Offset: 000001480000 , filesize: 512 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 57.96 KB/s
Partition name: UBOOT
Filename: lk.bin , Offset: 000007120000 , filesize: 417552 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 382.90 KB/s
Partition name: BOOTIMG
Filename: boot.img , Offset: 0000071A0000 , filesize: 4808704 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 771.06 KB/s
Partition name: RECOVERY
Filename: recovery.img , Offset: 0000077A0000 , filesize: 5685248 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 764.53 KB/s
Partition name: SEC_RO
Filename: secro.img , Offset: 000007DA0000 , filesize: 135168 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 577.82 KB/s
Partition name: LOGO
Filename: logo.bin , Offset: 000008420000 , filesize: 909312 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 690.56 KB/s
Partition name: EBR2
Filename: EBR2 , Offset: 000008720000 , filesize: 512 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 94.77 KB/s
Partition name: FRP
Filename: frp.bin , Offset: 0000091A0000 , filesize: 1048576 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 768.51 KB/s
Partition name: ANDROID
Filename: system.img , Offset: 000009800000 , filesize: 2474639360 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 775.54 KB/s
Partition name: CUST
Filename: cust.img , Offset: 00009D000000 , filesize: 419430400 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Done writing partition. Write speed: 776.45 KB/s
Partition name: CACHE
Filename: cache.img , Offset: 0000B6000000 , filesize: 5529820 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Sparse image found v.1.0 Total chunks: 16
Done writing partition. Write speed: 770.27 KB/s
Partition name: USRDATA
Filename: userdata.img , Offset: 0000BF600000 , filesize: 75408588 bytes
eMMC switching to ROM1
Erasing partition...
Writing partition...
Sparse image found v.1.0 Total chunks: 100
Done writing partition. Write speed: 777.07 KB/s

Writing DL_Info...
Writing DL_Info done

Partition PROTECT_F : formatting as EXT4. Please wait ...
Formatting completed
Partition PROTECT_S : formatting as EXT4. Please wait ...
Formatting completed

Writing eMMC Register ...
Reg: 179 Value: 0x48
Reg: 177 Value: 0x00
Reg: 162 Value: 0x01

All done time: [01:06:28:876]

HiPower mode is ON
Setting frequence to 7 MHz
CMD Pullup Level: 1701 mV
CMD Active Level: 1763 mV
EMMC Device Information :
EMMC CID: 150100464E31324D42002DD1555491C0
EMMC CSD: D02701320F5903FFF6DBFFEF8E40400C
EMMC Manufacture : SAMSUNG , EMMC NAME: FN12MB , HEX: 464E31324D42 , S/N: 2DD15554 , rev. 0x00
EMMC Manufacture ID: 0x15 , OEM ID: 0x00 , Device Type: BGA (Discrete embedded) , Date: 9/2014
EMMC ROM 1 (Main User Data) Capacity: 7456 MB (0001D2000000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 512 KB (000000080000) Counter: 0 , Response: Clean
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.7 (MMC 5.0, MMC 5.01)
Boot configuration [PARTITION_CONFIG]: 0x48 , Boot from: ROM2 (Boot partition 1)
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x01, RST_n signal is permanently enabled
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Device can have extended partitions attribute
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: FN12MB_2DD15554_20201014_000740.extcsd
EMMC Init completed.

Get firmware version


Brand = HUAWEI
Manufacturer = HUAWEI
Device = HWCUN-U6582
Model = HUAWEI CUN-U29
Phone platform = mt6582
CPU Abi = armeabi-v7a
Mediatek platform = MT6582
Android release = 5.1
Security Patch = 2017-03-05
Firmware version = CUN-U29C567B134
Firmware date = Thu Apr 13 14:55:51 CST 2017

HiPower mode is ON
Setting frequence to 7 MHz
CMD Pullup Level: 1711 mV
CMD Active Level: 1753 mV
EMMC Device Information :
EMMC CID: 90014A483847316505075819AE4834B8
EMMC CSD: D02701320F5903FFFFFFFFEF8A4040D2
EMMC Manufacture : SKHYNIX , EMMC NAME: H8G1e , HEX: 483847316500 , S/N: 5819AE48 , rev. 0x07
EMMC Manufacture ID: 0x90 , OEM ID: 0x4A , Device Type: BGA (Discrete embedded) , Date: 3/2017
EMMC ROM 1 (Main User Data) Capacity: 7456 MB (0001D2000000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 KB (000000400000) Counter: 0 , Response: Clean
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.7 (MMC 5.0, MMC 5.01)
Boot configuration [PARTITION_CONFIG]: 0x48 , Boot from: ROM2 (Boot partition 1)
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x01, RST_n signal is permanently enabled
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Device can have extended partitions attribute
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: H8G1e_5819AE48_20201014_004510.extcsd
EMMC Init completed.

Get firmware version


Brand = HUAWEI
Manufacturer = HUAWEI
Device = HWCUN-U6582
Model = HUAWEI CUN-U29
Phone platform = mt6582
CPU Abi = armeabi-v7a
Mediatek platform = MT6582
Android release = 5.1
Security Patch = 2017-03-05
Firmware version = CUN-U29C567B134
Firmware date = Thu Apr 13 14:55:51 CST 2017

pls help on how to solve .Thank you :)
 
Top