The phone is dead and i wan to upgrade it to 2gb ram and 16gb storage using kmr82.I just bought the emmc and inside have flash.Can give me step by step how to upgrade?
Regards
Regards
how to upgrade oppo mirror 3006 to 2+16 storage
- Thread starter ham_sang
- Start date
Deepesh Sharma
Friend's Martview
First the mobile is dead and before i change emmc SAMSUNG KMR820001M-B609 i factory reset and set user area enabled for boot then i write flash file (mirror3ex 14068-8gb "photo attached" ) and now when turn on, phone vibrate only and stuck at 0.07-0.08 amp.
4
4
Last edited:
maanarman
Friend's Martview
You need to following some steps for replace eMMC
1, Factory format and upgrade eMMC Firmware
2, Edit Cid which supported your firmware
3, Set a partition BOOT1 4096Kib BOOT2 4096Kib Userdata depend on your eMMC size
4, if you have dump just write in eMMC general tab boot1 boot2 userdata and csd
5, if you not have dump goto factory image tab select mtk and write normal firmware of you device
note : This five step most important if you make mistake you can't get success
best of luck
1, Factory format and upgrade eMMC Firmware
2, Edit Cid which supported your firmware
3, Set a partition BOOT1 4096Kib BOOT2 4096Kib Userdata depend on your eMMC size
4, if you have dump just write in eMMC general tab boot1 boot2 userdata and csd
5, if you not have dump goto factory image tab select mtk and write normal firmware of you device
note : This five step most important if you make mistake you can't get success
best of luck
