Solved oneplus 3T ,frp done !!

This topic has been solved

recan21

Active Member
Aug 2, 2019
87
21
Device : OnePlus A3003
Operation : Reset FRP
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM182)
Driver Info : Qualcomm Incorporated, qu_usb_serial.sys, 2.1.2.0
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1709400 [8996] B93D702A
OPK_DATA : 904DA9E6B158B218AA3E8F634004F5F11EB85C01FBA4D18DF92A2AFEB346E345
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8996_005]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : MSM8996, UFS, 64 GB
LU Count : 6 [0x00D7D800] [0x00000400] [0x00000400] [0x00008000] [0x00100000] [0x00060000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 131072, Sector Size: 4096
Reading Partition Table...OK
Reading Device Information...OK
Device : OnePlus [msm8996] [OnePlus3]
Software : , 1812060016 [Thu Dec 6 00:50:08 CST 2018]
Android Ver. : 8.0.0
Patch Level : 2018-11-01
Resetting FRP Lock.......Done
Operation Finished.
 
Top