oppo f5 plus chp1727 boot problem

mughal11

Member
Apr 11, 2017
7
0
Pakistan
trying to format this phone for forgotten code.
jumperd test point, and tried to format in mrt 2.60. formating process was not completed,
*now set is dead
cm2 2.15 reads following info.
please guide me how to solve it,
regardshttps://forum.**************/ubb/tongue.gif
------------------------------------------------------------------

Infinity-Box [ Chinese Miracle ] MediaTek Service Module [ MTK ] v2.15

Load IDBase v729152 Ok!


Operation : Identify [ v2.15 ]
Mode : FLASH

  1. Make sure device is powered off. Power off, if need. Wait 20 seconds after
  2. Insert USB cable in phone
Waiting for device connection ...

PTFN : MediaTek USB Port_V1632 (COM40)
MODE : BOOTROM
PORT : 40
Waiting BOOT ack ...
BROM : Skip ACK verify
BROM : Init BROM
BROM init passed!
CHIP : MT6763 , SBID : 0x8A00 , HWVR : 0xCA01 , SWVR : 0x0001
CODE : Bianco
TYPE : MODERN RAPHAEL
BROM : SecLevel : 0x000000E5
BROM : SecMode : SBC+SDA+ARB
BROM : BROM|BL : 0x05|0xFE
BROM : BOOTROM
MODE : 0_base : BASE_v2028 | Manual : Disabled
BROM : SOCID : 62F5493A6FF6977AC4D6AB626FC7D2B80CEF0ADC8069289073 543006F53C4971
BROM : ARB : ACTIVE : LOG : F0: 102B 0000 F3: 4001 0034 F7: 102D 0000 00: 1005 0000 F3: 4000 0036 F7: 102D 0000 01: 102A 0001
AGENT : Look for suitable BootChain in DA ...
AGENT : MTK_AllInOne_DA.bin
AGENT : Found MT6763
AGENT : MTK_DOWNLOAD_AGENT
BROM : Sending 1st DA ...

BROM : 0x00007017 : DA SEND ERROR!
ERROR : SECURE BOOT : SLA REQUIRED IN BROM MODE!
INFO : BROM Level : CERT/AUTH required! Try boot device in PRELOADER mode with select PL/PL_CRYPTO/SWSEC type!

Error : Fail to init protocol!
>> Remove battery, cable. Check cable/connection/driver! Check SW hint! Repeat operation!

Reconnect Power/Cable! 21553
 

clorosot

Junior Member
Nov 6, 2020
1
0
Philippines
i have a problem in this usb port installation sir because there is a yellow sign indicating error (this calls for unsigned driver)
 
Top