Hello I Have Samsung SM-G610F Inside Have On FRP Lock But Reset FRP UART Method Not Working In Octoplus FRP ToolSo Please Give Me Solution
Note:During Reset FRP UART Mobile Connect Successfully & Mobile In Upload Mode Hardware Reset Mode But In Device manager Modem Port Showing But During FRP Reset
Note:Inside This Firmware
PDA G610FDDU1CSK2
CSC G610FODD1CSJ2
Here LOG:
Platform: SAMSUNG
Selected model: SM-G610F
Searching for UART interface.. COM13
Connect Samsung Micro UART cable(with 525K resistor), press and hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Rebooting phone in Upload Mode...OK
Please connect phone to USB cable..
Searching for a phone. Please wait...
Please Give Me Solution
Thanks & Regards By:All TECH 4 You
Note:During Reset FRP UART Mobile Connect Successfully & Mobile In Upload Mode Hardware Reset Mode But In Device manager Modem Port Showing But During FRP Reset
Note:Inside This Firmware
PDA G610FDDU1CSK2
CSC G610FODD1CSJ2
Here LOG:
Platform: SAMSUNG
Selected model: SM-G610F
Searching for UART interface.. COM13
Connect Samsung Micro UART cable(with 525K resistor), press and hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Rebooting phone in Upload Mode...OK
Please connect phone to USB cable..
Searching for a phone. Please wait...
Please Give Me Solution
Thanks & Regards By:All TECH 4 You