VNUS Z85 format ok but strill freeze an logo .
i cant read firmware **
format info :
1. Power off device, wait 10-15 seconds
2. Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
3. Insert cable in device!
Wait for device ...
Device Connected!
BootVersion : SPRD3
Boot : INF : 0_SC7731x_BASE : SC7731G_eMMC_1GB_NS
Sending Init Boot ...
Boot sent!
Kick FDL ...
Kick FDL again ...
BootVersion : Spreadtrum Boot Block version 1.1
Protocol setup ...
Port speed : 921600
Sending Flash Boot ...
Boot sent!
Kick FLASH FDL ...
FDL : Control transfered!
Boot Done!
Wipe Ok : Forced Wipe
Wipe Ok : Forced Wipe
reg
Reconnect Power/Cable!
Done!
Elapsed: 00:00:28
i cant read firmware **
format info :
1. Power off device, wait 10-15 seconds
2. Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
3. Insert cable in device!
Wait for device ...
Device Connected!
BootVersion : SPRD3
Boot : INF : 0_SC7731x_BASE : SC7731G_eMMC_1GB_NS
Sending Init Boot ...
Boot sent!
Kick FDL ...
Kick FDL again ...
BootVersion : Spreadtrum Boot Block version 1.1
Protocol setup ...
Port speed : 921600
Sending Flash Boot ...
Boot sent!
Kick FLASH FDL ...
FDL : Control transfered!
Boot Done!
Wipe Ok : Forced Wipe
Wipe Ok : Forced Wipe
reg
Reconnect Power/Cable!
Done!
Elapsed: 00:00:28