UFi Failed to initialize eMMC (return code: 6, CMD Error: Invalid Voltage Range) !!!

[alkesh]

Boot version: 1.05, FW version: 1.13 (Aug 19 2019 23:46:09)
Insertion test... Done
Init bus...
VCC: 3.3 V, VCCQ: 1.8 V
Failed to initialize eMMC (return code: 6, CMD Error: Invalid Voltage Range) !!!
CMD1 error, cmd response: 0x40FF8080, card state: 255 (Card is in unknown state)
SEND_OP_COND command failed.
--- Card might be DEAD, for OLD moviNAND(Samsung) eMMC you may update the firmware with TestPoint ! ---

 

[alkesh]

Boot version: 1.05, FW version: 1.13 (Aug 19 2019 23:46:09)
Insertion test... Done
Init bus...
VCC: 3.3 V, VCCQ: 3.0 V
Bus: 1 bit (HS SDR 52MHz)
Access mode: sector mode
Power supply: dual-voltage (1.70-1.95V, 2.7-3.6V)
Card/BGA: Card (removable) - MMC
Manufacturer ID: 0x65 (Unknown)
Product name: M MOR (0x4d204d4f5202), rev: 0x40, serial number: 0x010012C0
Manufacturing date: ? 2013
CID: 65646F4D 204D4F52 02400100 12C000F4
Bad CID detected, eMMC might be damaged !!!
CSD: D07FFF32 0F59007F F6DB8000 1E40001C
Bad CSD detected, eMMC might be damaged !!!
EXT_CSD revision: 1.5 (MMC v4.41)
Failed to switch partition to 3, error code: 0
CMD8 error, cmd response: 0x900, card state: 4 (Card is in transfer state)
Error: failed to switch to RPMB partition.
Partition info:
Boot1: 2 MiB
Boot2: 2 MiB
RPMB: 128 KiB
User area: 128 MiB(134,217,728 bytes)
Partition configuration: 0x78
Boot acknowledge is sent during the boot operation
User area is enabled for boot
Partitioning support: 0x03
Device support partitioning feature
Device can have enhanced technological features
Device partitioning possible
Boot configuration protection: 0x00
Boot bus conditions: 0x00
Boot area write protection: 0x00

 

[ernestobieze9288]

how can i fix this

 

[JAJANG ABDUL ROHMAN]

Failed to initialize eMMC (return code: 6, CMD Error: Invalid Voltage Range) !!!
CMD0 error, cmd response: 0x40FF8080, card state: 255 (Card is in unknown state)
GO_IDLE_STATE command failed.

 

[Boopathi]

Failed to initialize eMMC (return code: 0, CMD Error: ) !!!
CMD0 error, cmd response: 0x0, card state: 0 (Card is in unknown state)
GO_IDLE_STATE command failed.


how can i fix