Solved Nokia 8.1 Hang on logo emmc - 90% consumed health repair success with ufi

[waseemmamu]

Connection status: IUSB3HUB[#2]:USB 2.00 High-Speed
Interface: UFI High-Speed
Serial number: 0011-8840-6612
Boot version: 1.04, FW version: 1.13 (Aug 19 2019 23:46:09)
Insertion test... Done
Init bus...
VCC: 2.8 V, VCCQ: 1.8 V
Bus: 1 bit (SDR 24MHz)
Access mode: sector mode
Power supply: dual-voltage (1.70-1.95V, 2.7-3.6V)
Card/BGA: BGA (Discrete embedded) - High density MMC
Manufacturer ID: 0x90 (SK Hynix)
Product name: HCG8a4 (0x484347386134), rev: 0xA2, serial number: 0x4F70E471
Manufacturing date: Oct 2018
CID: 90014A48 43473861 34A24F70 E471A552
CSD: D0270132 8F5903FF FFFFFFEF 8A400026
EXT_CSD revision: 1.8 (MMC v5.1)
Partition info:
Boot1: 4 MiB
Boot2: 4 MiB
RPMB: 4 MiB [Provisioned, counter: 30487]
User area: 58.24 GiB(62,537,072,640 bytes)
Cache size: 1 MiB
Hardware reset function: 1
Partition configuration: 0x38
No boot acknowledge is sent (default)
User area is enabled for boot
Partitioning support: 0x07
Device support partitioning feature
Device can have enhanced technological features
Device partitioning possible
Boot configuration protection: 0x00
Boot bus conditions: 0x00
Boot area write protection: 0x00

ANDROID System Info:
platform: sdm710, cpu abi: arm64-v8a
board: PNX, name: Phoenix_00WW
brand: Nokia, model: Nokia 8.1 ()
build id: QKQ1.190828.002, version: 10 [Android 10] (00WW_4_31A)

crypto state: encrypted?
eMMC 5.x Health report:
Device lifetime: Urgent (Consumed 90% of the reserved block)
Estimation of the device lifetime (SLC): 0% - 10% device life time used
Estimation of the device lifetime (MLC): Exceeded its maximum estimated device life time
eMMC selected: [HYNIX] H9HP52ACPMMDAR-KMM/64GB (BGA254)

 

[vk294184]

After repair emmc 'your device is currpted'
Any solution