BG2-U01 Userlock Frp Remove CM2 Dongle
Before Unlocking The BG2-U01 Userlock Frp, Make Sure The Following Steps Are Performed:
Download Install SPD Driver
LINK - DOWNLOAD
Login Username & Password On CM2SP2
Choose Firmware PAC ROM On CM2 FDL
Download BG2-U01 Pac Firmware
LINK - DOWNLOAD
Operation : Format FS / Reset Settings [ v2.14 ]
Mode : Default [ Reset Settings + FRP ]
BootMode : FLASH
- Power off device, wait 10-15 seconds
- Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
- Insert cable in device!
Wait for device …
Device Connected!
BootVersion : SPRD3
Boot : PAC : 2019-02-25-19-26-29.pac
Sending Init Boot …
Boot sent!
Kick FDL …
Kick FDL again …
BootVersion : Spreadtrum Boot Block version 1.1
Protocol setup …
Port speed : 921600
Sending Flash Boot …
Boot sent!
Kick FLASH FDL …
FDL : Control transfered!
Boot Done!
Wipe Ok : UserData
Wipe Ok : Cache
Wipe Ok : FRP
Reconnect Power/Cable!
Done!
Elapsed: 00:00:48
Download CM2 SP2 Lasted Version
LINK - DOWNLOAD