Disabling Android Locks...Done Successfully But Lock Still Same: Device : Xiaomi Redmi S2 Operation : Disable Locks Checking for existing devices...Not Found Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable. Some phones may need Special Boot Cable or TestPoint for EDL mode. Found Port : Qualcomm HS-USB QDLoader 9008 (COM443) Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2 Connecting to phone...OK Waiting for response...Ignored Init Handshake Sequence...OK Hardware ID : E1600400 [8953] 00000000 OPK_DATA : 079E496E26A477B120DFCD85DF7E4AD067164D8292DDD37993 0D5891E3D8240B Initializing Protocol...OK Using Auto Loader Selection [1] Preparing Loader...Done Sending Loader [8953]...Done Executing Loader...OK Detecting Chip Type...OK Hardware : 8953, eMMC, 32 GB LU Count : 1 [0x03A3E000] WARNING! High Speed Driver is not installed. Please install driver from QcFire\Drivers folder using Device Manager. Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512 Reading Partition Table...OK Reading Device Information...OK Device : Xiaomi Redmi S2 Software : PKQ1.181203.001, V11.0.5.0.PEFMIXM [Fri Mar 6 11:35:24 WIB 2020] Android Ver. : 9 Patch Level : 2020-03-01 USERDATA : Encrypted Disabling Android Locks...Done Operation Finished. QcFire Ver. 4.2 Note:I Also Try Read Pattern Lock & Reset Locks But Problem Still Same So Please Solve My Problem Special Note:If Any Dongle & Box Support Remove Screen Lock Without Loss Any DATA Please Tell Me. Thanks & Regards By:All TECH 4 You |