Can't init device, Reason: CMD Timeout Error solution PLZ
- Thread starter GSM SOFTWARE KING
- Start date
Z3X EasyJtag Software ver. 3.7.0.20
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: 1616120653F9FBE6, ,FW Ver.: 01.63
CMD Pullup Level:360 mV
CMD Active Level:1980 mV
Box IO Level:2800 mV
CLK Rate:21000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
Can't init device, Reason: CMD Timeout Error
Done.
i have the same problem. all phones i connect with easyjtag box i get same error i also change adapter but still same error i used other tool it connect fine.could it be box problem? if yes how to fix?
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: 1616120653F9FBE6, ,FW Ver.: 01.63
CMD Pullup Level:360 mV
CMD Active Level:1980 mV
Box IO Level:2800 mV
CLK Rate:21000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
Can't init device, Reason: CMD Timeout Error
Done.
i have the same problem. all phones i connect with easyjtag box i get same error i also change adapter but still same error i used other tool it connect fine.could it be box problem? if yes how to fix?