Chimera N971n Samsung note 10 5g Stuck in eub mode

[bakoteck]

Please I need help

N971n
Samsung note 10 5g

Stuck in eub mode.
The chimera update is not re connecting with the power button.

It just keep connecting and disconnecting.

In the old chimera. I just need to keep holding the power button and the device will reconnect.
The new chimera keeps disconnecting even with the power button pressed down.

I updated drivers
I have disconnected the battery and connect again.

 

[sweetboy]

keep holding power button and try connecting have to do repair boot it will come donload mode u have to flash phone

 

[professorlinux]

two ways: keep holding the power button
or press power button and release it with an interval of 1 second (repeat pressing and releasing many times)

 

[ChimeraTool]

Please I need help

N971n
Samsung note 10 5g

Stuck in eub mode.
The chimera update is not re connecting with the power button.

It just keep connecting and disconnecting.

In the old chimera. I just need to keep holding the power button and the device will reconnect.
The new chimera keeps disconnecting even with the power button pressed down.

I updated drivers
I have disconnected the battery and connect again.

Dear User,

In this case I'm afraid the UsbDk driver is not functioning properly, and you should make sure that you don't have TEST MODE enabled on your Windows.

Best Regards,
ChimeraTeam

 

[murtazahassan23123]

Please I need help

N971n
Samsung note 10 5g

Stuck in eub mode.
The chimera update is not re connecting with the power button.

It just keep connecting and disconnecting.

In the old chimera. I just need to keep holding the power button and the device will reconnect.
The new chimera keeps disconnecting even with the power button pressed down.

I updated drivers
I have disconnected the battery and connect again.

hello sir i am also stuck on same problem did you sloved that

 

[murtazahassan23123]

Dear User,

In this case I'm afraid the UsbDk driver is not functioning properly, and you should make sure that you don't have TEST MODE enabled on your Windows.

Best Regards,
ChimeraTeam

Dear User,

In this case I'm afraid the UsbDk driver is not functioning properly, and you should make sure that you don't have TEST MODE enabled on your Windows.

Best Regards,
ChimeraTeam

hello sir my windows is not in test mode and UsbDK driver is install but again same probelm

 

[ChimeraTool]

hello sir my windows is not in test mode and UsbDK driver is install but again same probelm

Dear User,

What is the exact firmware installed on your N971N?

Do you see the "UsbDk" or "Exynos" port appear in Windows Device Manager upon connecting the phone via test points?

Best Regards,
ChimeraTeam