• Remove FRP BQ Aquaris U2 7.1.2 BY Ultimate Multi Tool - QcFire •
♦ Test point
♦ remove FRP
Best regardis
♦ Test point
♦ remove FRP
Code:
Operation : Reset FRP
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM57)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1B00600 [8937] 00000000
OPK_DATA : 9CBA94693C2333A562BCF0E0E981C558748817D002F543B2A26AB1B4B3F1CF9E
Initializing Protocol...OK
Using Auto Loader Selection [3]
Device may possibly not boot with this loader.
Preparing Loader...Done
Sending Loader [8937_003]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8937, eMMC, 32 GB
LU Count : 1 [0x03A3E000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : bq Aquaris U2 [msm8937] [yamcha]
Software : 1.13.0_20180606-0917, 1.13.0_20180606-0917 [Wed Jun 6 09:36:45 CEST 2018]
Android Ver. : 7.1.2
Patch Level : 2018-06-01
Resetting FRP Lock......Done
Operation Finished.
QcFire Ver. 5.5
Best regardis