Z3X XT2305-1 Frp how to ?

[ramon9622]

Host Power Off... OK
Switch virtual port to NONE... OK
Connect Type-C to HUB... OK
Host Power On... OK
Connect phone to [BOX or PC] in BROM/PRELOADER Mode
Waiting for device... OK
Driver: [MediaTek Inc.,wdm_usb,MediaTek PreLoader USB VCOM (Android),usb2ser.sys,3.0.1504.0]
Device found at COM7 [PRELOADER]
Open port... OK
Send start cmd... OK
Get HW code from device... 1007
Get sec config... OK [00000005]
Active sec flags: [SBC DAA]
Get HW & SW version from device... OK
HW VER: CA01, SW VER: 0000, HW SUB CODE: 8A00
Detect chip [MT6879]
Library Version [2]
Select platform... OK
Init BROM... OK
Force Charge... OK
Disable WatchDog Timer... OK
Reopen port for libver2... OK
Preloader exist. Skip connection verification.
Get ME ID... OK
ME_ID = 0xC4F31562, 0x98256EE1, 0x88E19077, 0xFA1FA845
Get Chip ID... [MT1007]
Get SOC ID... [68999DA855C19FBDCA9D47C04338CD60628B2151EE0B72E6D1BF03008F589484]
Get sec config... OK [00000005]
Load DownloadAgent... OK
Search DA... not found


Selected model: Motorola XT2305-1 (Edge 2023)
Operation: Erase FRP
Software version: 9.25