Welcome to Octoplus Huawei Software v.1.3.5.4
To enable 'Manufacture' mode dial
- for Qualcomm and Hisilicon based models: *#*#2846579#*#*
ProjectMenu > Background Settings > USB Port Settings > Manufacture Mode
- for MTK based models: *#*#14789632#*#*
ProjectMenu > Background Settings > USB Port Settings > Debug Mode
To enable 'Fastboot' mode
1. Power off the phone. Remove SD and SIM cards
2. Press 'Vol-' and insert USB cable
3. Wait until phone enters 'Fastboot' mode
To enable 'Upgrade' mode
1. Power off the phone. Remove SD and SIM cards
2. Press and hold 'Vol-' and 'Vol+' keys and insert USB cable
3. Wait until phone enters 'Upgrade mode'
Found COM ports:
1: COM3 Intel(R) Active Management Technology - SOL
2: COM1 Communications Port
3: COM20 USB Serial Port
4: COM43 HUAWEI USB COM 1.0
Job ID: 00000000019115D0
2025-11-05 06:14:42
Starting Reset FRP
Selected phone model: ANE-L01
Warning: Please, make sure the phone`s battery is fully charged and connected, after connect the device via Factory Mode (use Hardware Test Point or "ON/OFF Factory Mode option").
Warning: Selected response: Proceed
Searching HUAWEI USB COM 1.0 port...
Detected HUAWEI USB COM 1.0 port
Phone connect successfully
Writing XLOADER partition...
Writing FASTBOOT partition...
Bootloader Update successfully
Rebooting to fastboot mode...
Searching Fastboot devices...
Found android device: 8GP7N18B13000353
Detected Android Sooner Single ADB Interface port
Reading basic data...
Device Model: ANE-LX2
System: 9.1.0.262(ZAFC185E4R1P8)
Android Version: 8.0.0
FB Lock State: UNLOCKED
User Lock State: LOCKED
Writing FRP partition..
Reset FRP done.
Performed by 1.3.5.4 Software version.
