Infinix Hot 10i_PR652B Frp Lock Remove CM2 Dongle
Before Unlocking The Infinix Hot 10i_PR652B Frp Remove, Make Sure The Following Steps Are Performed:
Login Username & Password On CM2SP2
Infinity-Box Chinese Miracle II : SPD/USC Module [SP2] v2.14
Load IDBase v8331 Ok!
Operation : Format FS / Reset Settings [ v2.14 ]
Mode : Reset FRP
BootMode : FLASH
- Power off device, wait 10-15 seconds
- Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
- Insert cable in device!
Wait for device …
Device Connected!
BootVersion : SPRD3
Boot : INF : 0_SC9863x_BASE : Tecno-PR652B
Sending Init Boot …
Boot sent!
Kick FDL …
BootVersion : Spreadtrum Boot Block version 1.1
Protocol setup …
Port speed : 921600
Sending Flash Boot …
Boot sent!
Kick FLASH FDL …
FDL : 0x0020
FDL : EMMC_RO : False ; EMMC_PART : True ; EMMC_RPMB_SET : False
FDL : RAW : 0x0002
FDL : FLH : 0x400000
FDL : SEC : RSA auth required!
FDL : Process authentification …
FDL : SEC : RSA auth passed!
FDL : Control transfered!
Boot Done!
Wipe Ok : FRP
Reconnect Power/Cable!
Done!
Elapsed: 00:01:32
