New Newest V12.25 XGECU T48 TL866II Plus High-speed Flash EPROM Universal Programmer with Adapters

Martview · Jan 25, 2024

Wide range of support:

EMMC function introduction:

Read and write speeds up to 17M Bytes /s, Max capacity: 256GB
Support ISP in-circuit programming
1b MODE speed: 4.7MB/s 4b Mode 17MB/s
Analysis EMMC function
show EMMC manufacturing and device lifetime information
show memory usage of 8 partitions
Each partition shows whether it is write-protected
Shows whether the entire chip is temporarily or permanently
write protected
Show whether the chip is password-protected
Show whether the EMMC uses a 32-bit security authentication code to write to the RPMB.
Show other important parameters of ECSD/CSD/CID
Read/write functions (all functions can be completed with one key)
Read CID CSD ECSD.
Clear full-chip temporary write protection before programming
Clear temporary write protection groups before programming
Erase chip before programming
Blank check the chip before programming
Programming 32-bit authentication key password verification
Partition Config
Read and Programming to BOOT1
Read and Programming to BOOT2
Read and Programming to RPMB
Read and Programming to GPP1/GPP2/GPP3/GPP4
Read and Programming user data(User Area)
Setting temporary write protection groups
Setting permanent write protection groups
Setting password(or reset password)
Programming ECSD
Programming CSD
Automatically verify all the above operations after Programming

NAND function introduction:

Function:

Support OTP programming
Support internal ECC on/off function
Support UID(unique signature)reading
Support multiple partitions and multiple file operations
Support NAND parameter custom function (new chips can be added by custom parameters)
The programming clock speed and VCC/VIO voltage are adjustable.
Support 1.8V and 16-bit device
Support ISP programming of SPI NAND (MAX 3.2MB/s)
Package type: DIP8/SOIC8/SOIC16/WSON8/BGA24/BGA63/TSOP48

Specification:

32-bit MCU120 MHZ USB2.0 HS480MHZ transmission
40+16=56 I0 output pins, extremely high reliability
Stable and reliable 1SP interface, line length of 25CM or more, reliable communication at 30MHZ.
Maximum clock frequency up to 30MHZ-40MHZ for 25 series/EMMC online programming.
VCC voltage 1.8-6.5V64 level adjustable; VPP voltage 9.0-25V64 level adjustable.
I0 communication signal voltage 1.8V-3.6V adjustable
VCC120MA-320MA overcurrent protection continuously adjustable; VPP120MA overcurrent protection
Power consumption: 5V<500MA static power consumption: 80MA all chips without external power supply
Internal multi-protection: overvoltage protection / reverse connection protection / three-level overcurrent protection voltage is too low to mention the deficit
Open self-test function, self-test each way VPP/VCC/GND/IO