NOKITA 6 (TA-1021) FRP RESET IN EDL MODE UMT DONGLE
Device : Nokia TA-1021
Operation : Reset FRP
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.7
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1F00400 [8937] 00000000
OPK_DATA : A57FDEEB0D02233786D8DDCA8A9889D62F92D43EE56EAC9966024663C39A5B06
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8937_011]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8937, EMMC, 32 GB
LU Count : 1 [0x03A3E000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 16384, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : FIH FIH-D1C-FIH [PLE]
Brand : FIH
Prod.Name : D1C_00WW_FIH
Software : 00WW_6_19D, 00WW_6_19D [Wed Apr 8 11:48:39 CST 2020]
Android Ver. : 9
Patch Level : 2020-04-01
Resetting FRP Lock......Done
Operation Finished.
QcFire Ver. 6.7
