when i connect isp connection i have problem
VCC: 2.8 V, VCCQ: 1.8 V
Failed to initialize eMMC (return code: 20, CMD Error: Invalid response) !!!
CMD1 error, cmd response: 0x3FC000F, card state: 255 (Card is in unknown state)
SEND_OP_COND command failed.
--- Check eMMC pins and connection ---
--- Try to select correct VCC/VCCQ manually ---
--- Try to decrease the clock speed ---
Help Me Sir cenior member
see it all friend's ur solve on this video
Sent From [friends-mobile by (ssm)] Using Martview Forum App
when i connect isp connection i have problem
VCC: 2.8 V, VCCQ: 1.8 V
Failed to initialize eMMC (return code: 20, CMD Error: Invalid response) !!!
CMD1 error, cmd response: 0x3FC000F, card state: 255 (Card is in unknown state)
SEND_OP_COND command failed.
--- Check eMMC pins and connection ---
--- Try to select correct VCC/VCCQ manually ---
--- Try to decrease the clock speed ---
Help Me Sir cenior member
CLK, CMD 100% CONNECTED, BUT PROBLEM IS STILL
HELP ME SIR.
Connection status: XHCI:HUB3:HUB3:USB 2.00 High-Speed
Interface: UFI High-Speed
Serial number: 0011-8840-6685
Boot version: 1.04, FW version: 1.12 (Jun 7 2018 00:06:47)
Insertion test... CLK, CMD not properly connected
Init bus...
VCC: 3.3 V, VCCQ: 1.8 V
Failed to initialize eMMC (return code: 17, CMD Error: Timeout) !!!
CMD55 error, cmd response: 0xFFFFFFFF, card state: 255 (Card is in unknown state)
Good thanksi face same error after many try i found solution
Set : VCC > 2.8 & VCCq: 1.8v
Then Again identify