Device : Oppo/Realme Bypass SM6115 (Snapdragon 662)
Operation : Reset FRP
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
SAMSUNG : Turn Off phone, hold EDL Cable Button and insert to phone and
press VOL DOWN + POWER on phone more than 3 times rapidly and then leave EDL Cable Button.
SAMSUNG (NEW) : Turn Off phone, hold EDL Cable Button and insert to phone and
press VOL UP + DOWN on phone more than 3 times rapidly and then leave EDL Cable Button.
OPPO/REALME : Use Vol Down + Power to Enter Recovery > Select Language > Connect Cable
then tap 3 times on Version shown at bottom center > Click Yes.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM3)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Protocol Ver. : 2
Hardware ID : E1D01400 [SDM662] 00005100
OPK_DATA : 19CF99D55CA3B2E11EA19E52E3541DEDF01898FD9F8C40E62548F1C7F60ABD47
Initializing Protocol...OK
Using Pre-Defined Loader [OPPOSM6115.ufl]
Preparing Loader...Done
Sending Loader [OPPOSM6115]...Write Error!
Please use correct loader and check USB port / cable.
Operation Finished.
QcFire Ver. 13.5
Operation : Reset FRP
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
SAMSUNG : Turn Off phone, hold EDL Cable Button and insert to phone and
press VOL DOWN + POWER on phone more than 3 times rapidly and then leave EDL Cable Button.
SAMSUNG (NEW) : Turn Off phone, hold EDL Cable Button and insert to phone and
press VOL UP + DOWN on phone more than 3 times rapidly and then leave EDL Cable Button.
OPPO/REALME : Use Vol Down + Power to Enter Recovery > Select Language > Connect Cable
then tap 3 times on Version shown at bottom center > Click Yes.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM3)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Protocol Ver. : 2
Hardware ID : E1D01400 [SDM662] 00005100
OPK_DATA : 19CF99D55CA3B2E11EA19E52E3541DEDF01898FD9F8C40E62548F1C7F60ABD47
Initializing Protocol...OK
Using Pre-Defined Loader [OPPOSM6115.ufl]
Preparing Loader...Done
Sending Loader [OPPOSM6115]...Write Error!
Please use correct loader and check USB port / cable.
Operation Finished.
QcFire Ver. 13.5