OPPO F11 CPH1911 PATTERN AND FRP RESET

maridick

Junior Member
Apr 15, 2020
1
0
Bali
Hello, i am new to Ufi Box. I have cph1911. i am using 4 pins isp (data0, cmd, clk and gnd) the other 2 (vcc and vccq) are using usb cable and without battery. when i do a factory reset the usb (i think) is disconnected and connected again, and when it reconnected ufi says error the same as the picture on this post. and now get stuck at mtk preloader mode. I tried many times and always get the same error.
my question is..is that the usb disconnect and reconnecting?
or please if someone have a complete isp pinout picture to share!
thank you
 
Top