Solved Oppo f11 pro pattern and frp done

[Robtech]

just in second done.
1. NO green light
solution... Make jumper wires as short as possible
thanks Aetool
2. When read info tool get stuck at getting mobile version
solution...untick Analysis mobile version
3.Read info
4.make wipe
Done thanks Aetool

 

[khan1845]

just in second done.
1. NO green light
solution... Make jumper wires as short as possible
thanks Aetool
2. When read info tool get stuck at getting mobile version
solution...untick Analysis mobile version
3.Read info
4.make wipe
Done thanks Aetool

SHOW PICTURE PINOUT

 

[Robtech]

SHOW PICTURE PINOUT

i already desoldered but this is the pinout i used

 

[rogersmobiles]

Bro i dont understand why u used aetool while it a test point instead of you soldering pinouts.

Sent From Infinix X623 Using Martview Forum App

 

[rogersmobiles]

How many wires did you solder?

Sent From Infinix X623 Using Martview Forum App

 

[Robtech]

How many wires did you solder?

Sent From Infinix X623 Using Martview Forum App

only 3 wires D0, CLK and CMD, disconnect battery connect usb

 

[menaopos]

pls sir i tried all of you said but still no green light & phone dead just show mtk usb port

 

[Robtech]

pls sir i tried all of you said but still no green light & phone dead just show mtk usb port

dead only mtk remove CLK resistor and make jumper 100% tested
dont forget to connect ground
if still no green light
connect with switch off after all connection to pc and usb,
press and hold power button and switch on Ae tool switch

 

[otmanhaddad]

i already desoldered but this is the pinout i used

f11 pro just 3 isp

 

[Robtech]

f11 pro just 3 isp

CLK
CMD
DAT0
GND