can someone check if this oppo a5 (2020) cph 1931 emmc log is fine? phone gives me error recovery/boot is destroyed afer performing oppo reset using easy jtag tool. i have flashed it offline without success.
Setting interface to EasyJtag2/ISP
Setting bus width to 1 Bit
Setting frequence to 36 MHz
CMD Pullup Level: 2087 mV
CMD Active Level: 2662 mV
EMMC Device Information :
EMMC CID: 90014A68433861503E030912C97BA679
EMMC CSD: D02700328F5903FFFFFFFFEF8E400043
EMMC Manufacture : SKHYNIX , EMMC NAME: hC8aP> , HEX: 68433861503E , S/N: 0912C97B , rev. 0x03
EMMC Manufacture ID: 0x90 , OEM ID: 0x4A , Device Type: BGA (Discrete embedded) , Date: 10/2019
EMMC ROM 1 (Main User Data) Capacity: 59640 MB (000E8F800000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 16384 KB (000001000000) Counter: 3864 , Response: Not Clean
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.8 (MMC 5.1)
Boot configuration [PARTITION_CONFIG]: 0x38 , Boot from: ROM1 (Main User Area)
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x01, RST_n signal is permanently enabled
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Device can have extended partitions attribute
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x01
Backup saved: hC8aP__0912C97B_20200702_191534.extcsd
EMMC Init completed.
Operation: Reading S.M.A.R.T Report ...
Device Life Time Estimation (MLC) [269]: 0x01 0% - 10% device life time used
Device Life Time Estimation (SLC) [268]: 0x00 Not defined
Pre EOL information [267]: 0x01 Normal
Optimal Read Size [266]: 0x20 128 KB
Optimal Write Size [265]: 0x20 128 KB
Optimal Trim Unit Size [264]: 0x01 4 KB
Sent From POCOPHONE F1 Using Martview Forum App
Setting interface to EasyJtag2/ISP
Setting bus width to 1 Bit
Setting frequence to 36 MHz
CMD Pullup Level: 2087 mV
CMD Active Level: 2662 mV
EMMC Device Information :
EMMC CID: 90014A68433861503E030912C97BA679
EMMC CSD: D02700328F5903FFFFFFFFEF8E400043
EMMC Manufacture : SKHYNIX , EMMC NAME: hC8aP> , HEX: 68433861503E , S/N: 0912C97B , rev. 0x03
EMMC Manufacture ID: 0x90 , OEM ID: 0x4A , Device Type: BGA (Discrete embedded) , Date: 10/2019
EMMC ROM 1 (Main User Data) Capacity: 59640 MB (000E8F800000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 16384 KB (000001000000) Counter: 3864 , Response: Not Clean
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.8 (MMC 5.1)
Boot configuration [PARTITION_CONFIG]: 0x38 , Boot from: ROM1 (Main User Area)
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x01, RST_n signal is permanently enabled
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Device can have extended partitions attribute
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x01
Backup saved: hC8aP__0912C97B_20200702_191534.extcsd
EMMC Init completed.
Operation: Reading S.M.A.R.T Report ...
Device Life Time Estimation (MLC) [269]: 0x01 0% - 10% device life time used
Device Life Time Estimation (SLC) [268]: 0x00 Not defined
Pre EOL information [267]: 0x01 Normal
Optimal Read Size [266]: 0x20 128 KB
Optimal Write Size [265]: 0x20 128 KB
Optimal Trim Unit Size [264]: 0x01 4 KB
Sent From POCOPHONE F1 Using Martview Forum App
