Help Redmi note 5 after bl unlock with umt phone dead(help)

sysjeeb

Active Member
Oct 12, 2020
17
6
chattagram
log
Operation : Xiaomi Boot Patch
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM4)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.3.7
Connecting to phone...OK
Waiting for response...Ignored
Init Handshake Sequence...OK
Hardware ID : E1C00C00 [8996] 00000000
OPK_DATA : F7337FE47B192EF4D1BA34CB4E879F0C6B771D06D2DE87BF21F65BA3303834E1
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8996_016]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : MSM8996, EMMC, 32 GB
LU Count : 1 [0x03A3E000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 131072, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : Xiaomi Redmi Note 5 [whyred]
Brand : xiaomi
Prod.Name : whyred
Software : PKQ1.180904.001, 9.6.27 [Thu Jun 27 11:49:02 WIB 2019]
Android Ver. : 9
Patch Level : 2019-07-05
Processing Mi_8_Lite........Done
Rebooting to Fastboot...Done
Put phone in Fastboot mode if it is not in Fastboot Mode.
Then try Unlock BL in Fastboot Mode.
Operation Finished.
QcFire Ver. 7.3
my mistake:- mistakely select mi 8 lite and patch
phone now detect only 9008 port......
im trying to relock bl but same and trying also flash old or latest firmware also same.....
any solution without ufi or jtag???
 

eliaspy

Member
May 9, 2019
13
6
I'll tell you the real solution, no matter how many firmware you write, won't work. You need change PMIC (pm660), because the PMIC was flashed with the wrong firmware
 
Top