• Remove FRP ZTE N9136 [ Prestige 2 ] 6.0.1 ( EDL Mode ) By >>> Ultimate Multi Tool - QcFire •
• Reboot DFU To EDL Mode :
• Remove FRP :
Code:
Operation : Reset FRP
Checking for existing devices...Found
Port : Qualcomm HS-USB QDLoader 9008 (COM5)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2
Opening Port...OK
Init Handshake Sequence...OK
Hardware ID : E1009600 [8909] 00000400
OPK_DATA : A4F889863F66ABF67892BE4BFC68025AF5E25CB69AE2BAA25DFF4BCA141C5EBA
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8909_046]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8909, eMMC, 16 GB
LU Count : 1 [0x01D1F000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : ZTE N9136 [msm8909] [grayjoy]
Software : N9136V1.0.0B10, 20180806.155935 [Mon Aug 6 16:03:14 CST 2018]
Android Ver. : 6.0.1
Patch Level : 2018-07-01
Resetting FRP Lock......Done
Operation Finished.
QcFire Ver. 5.6