I have proper soldering but im still getting error cmd time error crc error
Cmd pull up levels help me sir
Here
Z3X EasyJtag Software ver. 3.7.0.20
Loading eMMC GEN2 Firmware... IO: 2200 mV
Box S/N: 41CA0C8A0DD5451C, ,FW Ver.: 02.53
Warning: CMD Pullup Level (190 mV) too low , check cables etc.!
CMD Active Level:213 mV
Box IO Level:2200 mV
CLK Rate:36000 kHz
Bus Width:1bit,SDR
HiPower mode is ON!
Can't init device, Reason: CMD Timeout Error
Done.Setting
EasyJtag2/ISP_HiPower
Setting bus width to 1 Bit
HiPower mode is ON
Setting frequence to 36 MHz
CMD Pullup Level: 784 mV
CMD Active Level: 1020 mV
Can't init device. Reason: CMD CRC Error