Samsung SM-G610F Reset FRP UART Method Not Working So Please Give Solution

[All TECH 4 You]

Hello I Have Samsung SM-G610F Inside Have On FRP Lock But Reset FRP UART Method Not Working In Octoplus FRP ToolSo Please Give Me Solution


Note:During Reset FRP UART Mobile Connect Successfully & Mobile In Upload Mode Hardware Reset Mode But In Device manager Modem Port Showing But During FRP Reset



Note:Inside This Firmware


PDA G610FDDU1CSK2
CSC G610FODD1CSJ2

Here LOG:



Platform: SAMSUNG
Selected model: SM-G610F
Searching for UART interface.. COM13
Connect Samsung Micro UART cable(with 525K resistor), press and hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Rebooting phone in Upload Mode...OK
Please connect phone to USB cable..
Searching for a phone. Please wait...





Please Give Me Solution


Thanks & Regards By:All TECH 4 You

 

[GiftedGsm]

first, alternative is that you can bypass the device , i did that weeks ago video link -

second, you can bypass with combination and full firmware - flash combination first, after then flash from full firmware bl, ap, cp AND MAKE SURE YOU REMOVE USERDATA IN THE (^AP^). after flashing it should skip frp .you can then factory reset. incase u have bootloop flash back only csc.

i will recommend u just to bypass to save u all the stress

give feedback