I think its working only for EasyJtag. Tested not working for UFI Box It only shows info but to reset function is not.
Confirmed isp pinout is correct.
nterface: UFI High-Speed
Serial number: 0011-8839-xxxx
Boot version: 1.04, FW version: 1.14 (Aug 25 2021 04:56:05)
Insertion test... Done
VCC, VCCQ not properly connected
Init bus...
VCC: 3.3 V, VCCQ: 3.0 V
Bus: 1 bit (SDR 52MHz)
Access mode: sector mode
Power supply: dual-voltage (1.70-1.95V, 2.7-3.6V)
Card/BGA: BGA (Discrete embedded) - High density MMC
Manufacturer ID: 0xD6 (Unknown)
Product name: 58A431 (0x353841343331), rev: 0x74, serial number: 0x9AC2A522
Manufacturing date: Apr 2021
CID: D6010335 38413433 31749AC2 A52248D8
CSD: D0FFFF32 9F5903FF FFFFFFEF 9640002C
Firmware version: 0x20603
EXT_CSD revision: 1.8 (MMC v5.1)
Error: failed to switch to RPMB partition.
Partition info:
Boot1: 0 B
Boot2: 0 B
RPMB: 0 B
User area: 0 B(0 bytes)
Cache size: 64 MiB