TechLife Pad Lite 8 FRP Remove DoneStart FRP Complete. Erase Userdata SoC T606 Boot [FF] FireFly v2.47 Partitions: 76 Backup exist C:\InfinityBox\CM2SP3\backup\SC9230_11b93dabd49ebc 02_techlife-tlpadl03-ums9230-6h10.7z Reset FRP... frp config found reset persist... Ok 78 us Completed(1) Reset Userdata... Format Auto => Format Wipe #1 userdata... Wiped Ok #2 cache... Wiped Ok #3 metadata... Wiped Ok Done(3) Stop [Job 31061683] FRP Complete. Erase Userdata v2.47 12 sec In case of recovery loop make Reset Userdata with [Make filesystem] Reboot... Disconnect cable if it freez |
Start Connect SoC T606 Boot [FF] FireFly v2.47
Power device Off and connect cable now
Remember Volume Up/Down or Test-Point
Waiting for device... SPRD U2S Diag (COM44) 1782:4D00
boot: SPRD3
boot iLoader... Ok
run iLoader... Ok
boot xLoader... Ok
run xLoader... Ok
Bootcode Handshake... Ok [FF] v2
Loader exec[0] Ok
Selected CPU [SC9230]
Dev UID: 11b93dabd49ebc0242223bc665c6c2bf6117418e0e3da4ecca a0703ca05cb049 00744604100dce11
hwid cache(6) stored C:\InfinityBox\CM2SP3\phdata\hwid_11b93dabd49ebc02 .txt
get flash type... EMMC
EMMC CID: C4010D545753432020B3C701D2F04C87 crc Ok
Vendor: Unknown 0x00C4 OEM: 0x010D ID: 545753432020 [TWSC ] PRV: 0xB3 Serial: 3338785520 0xC701D2F0
MM/YY: 4/2025
CSD: D02701320F5903FFFFFFFFEF8A404001
temp write protect: No
perm write protect: No
wp group: 0x10 en 0x01
EXTCSD rev1.8 EMMC 5.1 Firmware: B3
BOOT_CONFIG: 0x08 boot1
BOOT_BUS_WIDTH: 0x00
RST_N_FUNCTION: 0x01
PART_S_COMPLETED: No
BOOT size: 0x00400000 4.00 Mb
RPMB size: 0x01000000 16.00 Mb
Size Market 64 Gb; Actual 0xE90000000 58.25 Gb
EOL: Status: Normal: Less than 80% reserved blocks used
EOL_A: SLC status: 10% - 20% used
EOL_B: MLC status: 0% - 10% used
Load 1st GPT... Ok
1st GPT Ok
Connected
Partitions: 76
Slot info... slot: b
get sw info...
Probe boot... vendor_boot_b v4 lz4 ramdisk.size=57.50 Mb; found 2 props boot_b v4 ramsidk.size=0; Ok 25 sec
Probe vbmeta... End 15 us
Product Brand: TechLife
Product Device: TLPADL03
Product Model: TLPADL03
Product Name: TLPADL03
SW Version: 34531
Product Info: TLPADL03
Patch Level: AP3A.240905.015.A2
Display ID: P6062B_TechLife_TLPADL03_MP_20250718
Ver. CodeName: REL
Sec. Patch: 2025-06-05
Build Time: 18/07/2025 03:17:39
Product Manfct: TechLife
Board Platform: ums9230
Product Board: ums9230_6h10
ID: techlife-tlpadl03-ums9230-6h10
Strategy [none|generic]
Firmware ID: UMS9230_TechLife_TLPADL03_OSv15_P6062B_TechLife_TL PADL03_MP_20250718_AP3A.240905.015.A2_TLPADL03_wot a
OTA updated
Android ver: 15
userdata: [f2fs] FBE [file based encryption] cache: [f2fs]
Backup(17) to C:\InfinityBox\CM2SP3\backup\SC9230_11b93dabd49ebc 02_techlife-tlpadl03-ums9230-6h10\
Read...
#1/76 [prodnv] 64.00 Mb Ok [64.00 Mb] 57 sec
#2/76 [miscdata] 1024.00 Kb Ok [1024.00 Kb] 796 us
#4/76 [trustos_a] 6.00 Mb Ok [6.00 Mb] 5 sec
#5/76 [trustos_b] 6.00 Mb Ok [6.00 Mb] 5 sec
#6/76 [sml_a] 1024.00 Kb Ok [1024.00 Kb] 875 us
#7/76 [sml_b] 1024.00 Kb Ok [1024.00 Kb] 875 us
#8/76 [uboot_a] 3.00 Mb Ok [3.00 Mb] 2 sec
#9/76 [uboot_b] 3.00 Mb Ok [3.00 Mb] 2 sec
#13/76 [l_fixnv1_a] 2.00 Mb Ok [2.00 Mb] 1 sec
#14/76 [l_fixnv2_a] 2.00 Mb Ok [2.00 Mb] 1 sec
#15/76 [l_fixnv1_b] 2.00 Mb Ok [2.00 Mb] 1 sec
#16/76 [l_fixnv2_b] 2.00 Mb Ok [2.00 Mb] 1 sec
#32/76 [teecfg_a] 1024.00 Kb Ok [1024.00 Kb] 875 us
#33/76 [teecfg_b] 1024.00 Kb Ok [1024.00 Kb] 875 us
#73/76 [calinv] 2.00 Mb Ok [2.00 Mb] 1 sec File has only zeroes
#75/76 [splloader] 4.00 Mb Ok [4.00 Mb] 3 sec => 80.00 Kb => 64.76 Kb
#76/76 [splloader_bak] 4.00 Mb Ok [4.00 Mb] 3 sec => 80.00 Kb => 64.76 Kb
Saved 17 of 17 [95.14 Mb] to C:\InfinityBox\CM2SP3\backup\SC9230_11b93dabd49ebc 02_techlife-tlpadl03-ums9230-6h10\
probe rpmb... RPMB counter 0x000000D0
RPMB: C:\InfinityBox\CM2SP3\backup\SC9230_11b93dabd49ebc 02_techlife-tlpadl03-ums9230-6h10\rpmb_000000D0.bin
RPMB size 0x1000000
Read... Ok 1 min 2 sec
Done 18 files
Pack... Ok
Probe bootloader...
key mask=9, ver mask=1, key auto=b
Bootloader locked, oem|U
Stop [Job 31061683] Connect v2.47 3 min 39 sec
Set [Probe secondary gpt] On to load and verify 2nd GPT copy. Disable it if process stop/freez