always dying my emmc .
set was hamg on logo after repair bad health .emmc died
Z3X Emmc Manager
Z3X EasyJtag EMMC File Manager v 1.20 at 19/03/2021
Source: EasyJtag Port [EMMC/SD/MMC]
Generation: GPT [QC/SAMS/BCM/INTEL/MTK]
Box Voltage set to: 1800 mV
Scanner Thread Created..
Config: 1011111111101111
Setup HiPower CLK: OFF
Connecting To EasyJtag Plus Box: 1800mV/42MHz/1BIT
EasyJtag Plus Box Found! Result: 0/OK
EasyJtag Plus S/N: A86DA63E980B20E5
EasyJtag Plus Box FirmWare: 2.53.2
Box Bus Width = 8 BIT
Box Hardware = EasyJtag 2nd Generation
Search Emmc Chip...
Testing Box Interface
PIN CLK : 915 mV -> Pin OK
PIN CMD : 993 mV -> Pin OK
PIN DAT0: 855 mV -> Pin OK
PIN DAT1: 850 mV -> Pin OK
PIN DAT2: 854 mV -> Pin OK
PIN DAT3: 853 mV -> Pin OK
PIN DAT4: 854 mV -> Pin OK
PIN DAT5: 854 mV -> Pin OK
PIN DAT6: 852 mV -> Pin OK
PIN DAT7: 852 mV -> Pin OK
Test End
EMMC Chip Found! -105/CARD_LOCKED
EMMC CID: 450100444134303634011B28223EA51D
EMMC CSD: D00F00328F5903FFFFFFFFEF8A404023
EMMC VENDOR: SANDISK
EMMC NAME: DA4064
EMMC DATE: 10/2018
EMMC SERIAL: 1B28223E
EMMC REVISION: 01
EMMC ROM1 Size: 122142720 Block(s)/59640 MB
EMMC ROM2/3 Size: 8192 Block(s)/4096 KB
EMMC RPMB Size: 32768 Block(s)/16384 KB
EMMC RPMB Counter: 155422, State: Dirty
EMMC RPMB Answer: 0/OK
Error While Switch ROM: -105/CARD_LOCKED
This EMMC Locked by PassWord! Break..
Scanner Thread Terminated
Elapsed: 00:00:02:328
Found 3 Partition(s)..
Search Partitions Fail..
Check EMMC or Run Pool Test..
